Ummmm hi im still trying to learn how to use this tileset and I've basically got everything down except the houses.... I cannot for the life of me figure out exactly how to do it. I dont see the tiles you need to make a house look good so I was wondering If anyone could make a tutorial on how to map a house with this tileset.

And if you dont know what it is

Here:









And here are the houses Ive spent so much time trying to figure out how to make (basically all of them but ESPECIALLY the church)


Dont criticize me Im posting this asking for help and would very much appreciate it if someone did.....

Uhhh could someone help? I honestly cannot figure this out trust me I've been trying......

Wait...if you have the project with the tilesets then why didn't you use the tilesets/copy the format of the houses from the project? 

Anyway, of all the tilesets that you posted, you didn't post one crucial Mack tileset-
TileC, that contained the bue roof you were searching for:


How to use:

-Create a house as you usually would (TileA3)
-Create an extension of the house, eg: --------------------------
                                                     l                                   l
                                                     l             part A              l
                                                     l                                   l
                                                     ----------         ----------
                                                                   l        l
                                                                   l        l           -------->Extension
                                                                   l        l
                                                                   -------

-Place roof over the entire section of part A
-As for the 'small roofs' just place them over the roof tile. They're TileCs.

-As for the church, follow the ^ steps just that put the bell tower as events over the roof.

That's about it. Good luck.

Thank you very much that helps and is so much better than how I was attempting.......not criticizing you or anything but I was wondering if you knew how to make the house look like its not connected seperately like with the house in the upper left It looks like the roof is connected to the back Its kinda hard to explain...... If you dont get it I can try to elaborate better...

Thanks

actually if you go to http://www.megaupload.com/?d=DT0280LM within the project theres the map screenshot I showed Ive spent about 2 hours trying to replicate the houses he made Ive even tried layering over the house to see the steps he did but to no avail Im completely clueless....I'm stumped.

Oh and I do have the tile c I just did not notice that I didnt upload it sorry

Quote from: godlock2006 on October 12, 2011, 07:35:26 PM
not criticizing you or anything but I was wondering if you knew how to make the house look like its not connected seperately like with the house in the upper left It looks like the roof is connected to the back Its kinda hard to explain......

Use these tiles to overlap the top:


You might have to use events.

Quote from: godlock2006 on October 12, 2011, 07:35:26 PM
not criticizing you or anything but I was wondering if you knew how to make the house look like its not connected seperately like with the house in the upper left It looks like the roof is connected to the back Its kinda hard to explain......

Use the middle section of the triangular roof(TileC) and place it over the square roof(TileA3).